Mastercool 53500-C UV LEAK LOCATOR KITS Manuel d'utilisateur télécharger pdf

DYE INJECTION and UV LEAK DETECTION

PLEASE USE CAUTION!!

• When injecting dye into a pressurized system, ALWAYS wear safety glasses

and gloves!

• Never breathe refrigerant vapor!

• Never use the UV light without wearing the UV glasses!

• Lamp surfaces will get hot very quickly. DO NOT TOUCH THE LENS!

DYE INJECTION INSTRUCTIONS:

(4) (3) (2) (1)

A. Purging air from the hose assembly

It is important to eliminate any air in the hose before injecting dye into the A/C

system. (This process is necessary only once for the setup).

1. Hold the cartridge (2) upward while unscrewing the cap. Snap the hose

assembly (3) onto the cartridge.

2. While holding the assembly upward, attach the handle (1) to the bottom of the

cartridge by turning it clockwise. Continue turning as dye enters the hose and

pushes the air up. Use a pen to press the depressor of the coupler to release

the air. Repeat this process as needed until dye appears at the coupler’s end.

B. Injection

1. Turn the A/C system and engine off!!

2. Connect injector to the low side service port of A/C system. Hold body of

injector. Use ( I ) starting line on handle end as a guide. Turn handle clockwise

to inject 1 application of dye.

(Approximately 1 to 1 1/4 turn(s) for concentrated dye).

Concentrated Dye 25 Applications per Cartridge

(AUTOMOTIVE) 1 Application per system (for a system using up to 10 oz.

[300 ml] of lubricant)

(HVAC/R) 1 Application per system (for a system using up to 7 lbs.

[3.2 kg] of refrigerant)

3. Disconnect injector from the system and clean any excess dye left around the

service port.

Compact

UV Swivel Light

Mini

Light

LEAK DETECTION USING A UV LAMP:

A. Turn Engine and A/C system on.

B. Allow dye to circulate throughout system.

C. Connect UV lamp to power. (If using rechargeable UV Light, make sure the

battery is fully charged). SEE INSTRUCTIONS!!

D. WEAR PROTECTIVE GLASSES!!

E. Do not use lamp near ﬂammable materials, liquids or gases.

F. Never use lamp for more than 3 minutes at a time. Allow lamp to cool between

uses, 3 MINUTES ON, 5 MINUTES OFF. If used continuously, you may damage

glass lens.

G. Turn lamp on. Search for a bright green/yellow glow where the system is

leaking. Clean the area around leak after repair.

53100-C-INS

Résumé du contenu

Page 1 - B. Injection

DYE INJECTION and UV LEAK DETECTIONPLEASE USE CAUTION!!• When injecting dye into a pressurized system, ALWAYS wear safety glasses and gloves!• Ne

Commentaires sur ces manuels

Pas de commentaire

Mastercool 53500-C UV LEAK LOCATOR KITS Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Mastercool 53500-C UV LEAK LOCATOR KITS. Mastercool 53500-C UV LEAK LOCATOR KITS User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Mastercool 53500-C UV LEAK LOCATOR KITS